• Fusion

Course 4 - Haas and Autodesk Fusion - Machined Part Finishing and Inspection

Outline
1

Getting started

Module overview
Course overview
Get the software
Get the Haas tooling
Course resources
2

Create and rough a new setup for OP2

Module overview
Create a new setup for caliper and soft
Adaptive clear remaining stock
Face remaining stock
Practice exercise
Challenge exercise
Module quiz
3

Create toolpaths to machine the caliper OP2

Module overview
Rough the caliper with an adaptive toolpath
Use 2.5 axis toolpaths to finish caliper surfaces
Bore mounting holes
Chamfer edges
Practice exercise
Challenge exercise
Module quiz
4

Simulate toolpaths to validate stock removal

Module overview
Simulate toolpaths
Machine simulation
Create a setup sheet and NC program
Practice exercise
Challenge exercise
Module quiz
5

Machine the brake caliper OP2

Module overview
Set up soft jaws to be machined
Machine soft jaws
Module quiz
6

Final part inspection for the brake caliper

Module overview
Visual part inspection
Manual inspection setup
Manual part inspection
Probe geometry
Practice exercise
Challenge exercise
Module quiz
7

Course challenge exercise

Module overview
Course challenge
8

Final test

Module overview
Start your final test
  • Up next:Simulate toolpaths to validate stock removal

Module quiz

5 questions

1. With the WCS set on the top of a vise, the Bottom Height set at the same location and an Adaptive toolpath with .05 Radial stock to leave and .02 Axial stock to leave, what is the final Z height of the toolpath?

Error: Select an answer

2. What is a potential issue with using 2D Contour toolpaths on complex geometry?

Error: Select an answer

3. Which toolpath geometry option allows a 3D Adaptive Clearing toolpath to calculate remaining stock to be machined and avoid “air cutting” where stock has already been removed?

Error: Select an answer

4. Which selection is needed for a bore toolpath?

Error: Select an answer

5. What information can only be validated by machining a part?

Error: Select an answer

Error: 5/5 questions unanswered
5/5 questions unanswered
  • Up next:Simulate toolpaths to validate stock removal

Welcome ${RESELLERNAME} Customers

Please opt-in to receive reseller support

I agree that Autodesk may share my name and email address with ${RESELLERNAME} so that ${RESELLERNAME} may provide installation support and send me marketing communications.  I understand that the Reseller will be the party responsible for how this data will be used and managed.

Email is required Entered email is invalid.

No, thanks, I don't want support from ${RESELLERNAME}
${RESELLERNAME}